In addition you will need:
- chain nose pliers
- wire cutters
- round nose pliers
Start by putting the head pins through the bicones, bend the top part of the head pin at a slight angle, cut off excess of the head pin leaving enough space to form a loop. Make a loop with the round nose pliers making sure there is no gap where the end meets the pin.
Measure the chain to match the desired fit around the wrist, cut off it off with the wire cutters and attach the clasp and toggle at the ends. Put a charm on a jump ring and attach it to the second ring of the chain. Make sure to close the jump ring as tightly as possible so the charm won’t slip out. In our idea we used a bicone with a jump ring next, then another charm, then another bicone, etc. The order of the charms and bicones is completely down to you. For spacing, we left two rings of the chain as a space between each charm or bicone. Ready is your sparkling new bracelet that upon moving your wrist has a sound of far away sleigh bells. Try it!
Please note: This is just a creative idea and no individual instructions are provided. Buy beads online with I-Beads.